VACUUM PUMP OVERHAUL

​Send your pump to vacuum works for evaluation.  Following disassembly, we will confirm non-wear components are serviceable and send a quotation to perform our 15 point overhaul procedure including: 
  1. Disassembly and cleaning in a hot caustic bath.
  2. Dimensional verification of all internal moving components to assure they are within manufacturer’s tolerances.
  3. Reassembly with non-wear components that replace those found to be out of tolerance.
  4. Reassembly with new wear components including bearings, shaft seals, o-rings, gaskets, exhaust valve wear components, electrical solenoids, drive belts, ball valves and check valves.
  5. Motor evaluation to confirm bearings are fit for service and lubricated.
  6. Helium Leak Detector testing to verify vacuum leak free assembly
  7. Water Jacket Pressure Test to verify leak free water jacket
  8. Oil Reservoir Pressure Test to verify leak free oil reservoir
  9. 24 Hour Test Run to verify blank-off performance and confirm oil-leak free operation.
  10. Amp Draw Test to verify correct blank –off and loaded Amp Draw.  This can be used to diagnose future performance issues.
  11. Noise and Vibration evaluation to confirm correct levels
  12. Painting to restore new pump appearance
  13. Final test operation to verify vibration noise free operation following belt guard reassembly.
  14. Pallet mounting, stretch wrapping and chicken crating for shipment.
  15. Test report creation and inclusion with each pump.


 
Trade In Opportunity

If your broken pump has value, we will work with you to reduce the purchase price in exchange for your non-working pump,  clear your floor and reduce your cost.


 
On-Site Service

Vacuum Works has trained service technicians that travel to your site and perform many of the same services available when you send a pump to our facility.  Call us to receive an on-site quotation.